#CB ANTENNA COAX NEED BETTER EARS TV#

earbuds, charging cables, adapters, audio cables and so much more. RF is not a MOrrreeee Poweerrrrr! Tim Allen kinda thing! Too much RF can lead to all kinds of problems. Loves Mobile to Go products provide the quality technology you need with convenience. Lets work on optimizing the receive setup DECENT ANTENNA AND COAX first. I always use tuned commercial antennas for the band(s) I need.Ĭan't comment on below 30Mhz operations, don't do HF, and low band 30-50Mhz has pretty much dried up in the commercial and PS LMR arena.Īs for LNA's WHOOAAAA! LNA's or 'amps' have a time and place. To say I am not a fan of them would be putting it mildly. And they are about as useful as a wet noodle. Radiall started by manufacturing coaxial cables and connectors now, more than 60 years later.

#CB ANTENNA COAX NEED BETTER EARS TV#

Discones were developed for the wideband of the military. Do you ever find that your TV antenna needs a boost. Second, I personally would find a better antenna, one tuned to the frequencies you need. How do you plan to feed through the wall from outside to inside? So if you can get a pre made run all the better. In addition to two antennas and mounts, youll also need a special co-phase CB coax for wiring everything up.

The LMRxxx range can start to get pricey on the connectors and tools to do this right. RG11 is not, and will take different tool in some cases RG6 is readily available at most 'home' stores along with decent compression connectors. If you need any more advice on ground-planes or anything else regarding CB. You need to use RG6, RG11, YES CATV/OTA Cable* OR LMR400, or 9913 or similar. A Groundplane is needed for any CB antenna to work, without it the antenna. TLDR: how do I connect an SDR to a discone antenna over 40 feet away?įirst, FORGET RG58 for that run! Its junk at that distance over that broad range. I have a Nooelec SmarTee XTR and an SDRplay The balun should be a lot easier to work with because I can position it much closer to the window. I plan on using the discone for signals from 25MHz to 2GHz, and then use a basic long wire antenna with a balun for things below 25MHz. This RG8x coax cable is used for CB ham radio, antenna analyzer, tuner, switch, monitor, dummy load. The question is, can I connect an SDR to a discone antenna through 56 feet of cable? Can I use standard RG-58 SMA coax or should I use something else? Should I use an LNA somewhere on the line? Is it even worth it to try and use this clothes line pole when it's this far away? Better than RG58, RG8x coax cable has 17AWG thicker pure copper inner conductor, is a step up from standard RG-58 coaxial cable and is recommended for high-powered applications or users who simply want the best coax possible. I estimate I'll need about 10 feet to get up the pole and about 5 feet to get in the window and to my SDR, adding up to 56 feet

There's an unused clothes line pole about 41 feet from the window of my office that I want to attach a pole and a discone antenna to. I recently moved into a new place and I've been looking to get my SDR set up again, only this time with an outdoor antenna.

Cb antenna coax need better ears